Harrop MAP Sensor | 2.7 Bar | 39 PSI

Harrop 2.7 Bar MAP Sensor for supported forced-induction applications.

This sensor is intended for boosted combinations requiring a higher pressure measurement range and is listed by Harrop as a direct replacement for VF Commodore applications using the late-type connector.

Key Details

• Maximum pressure rating: 2.7 Bar / 39 PSI
• Suitable for forced-induction applications
• Direct replacement for compatible VF Commodore sensors using the late-type connector
• Harrop product code 65-MAP-SENSOR2.7

Fitment

Confirm connector type, ECU calibration and required pressure range before ordering. Harrop notes that the displayed supplier image is representative and the supplied sensor may differ visually.

Built by Boost & Tune can assist with sensor selection, installation and calibration for supported performance combinations.

12-month Harrop limited warranty applies subject to Harrop's warranty conditions.

Product Details

Product: Harrop MAP Sensor | 2.7 Bar | 39 PSI
Brand: Harrop
Category: Wiring, Sensors & Displays

This listing covers the product and application named above. Use the product title, part number where shown, and the existing technical information on this page to confirm it matches the required vehicle or engine combination.

Before Ordering

• Confirm the listed application matches the vehicle, engine or component being upgraded.
• Check whether supporting hardware, fabrication, wiring, fluids, gaskets or calibration are required for the installation.
• If the vehicle has non-standard modifications, confirm compatibility before purchase.

Built by Boost & Tune Support

Built by Boost & Tune can assist with installation, wiring integration, sensor setup and calibration where required. Contact us before ordering if you need help confirming suitability or planning the complete upgrade package.