Haltech Bosch - DBW Pedal Assembly

Haltech Bosch Drive-by-Wire Pedal Assembly (HT-011900) provides accelerator-pedal position data to a compatible DBW-capable ECU or VCU.

Features

• Firewall-mounted hanging pedal design.
• 70mm pedal travel / approximately 16 degrees.
• Dual-potentiometer redundancy for DBW safety monitoring.
• Matching connector and pin set included.

Compatibility

For Haltech Nexus and supported Elite ECU/VCU systems with drive-by-wire throttle control. It is used together with a compatible electronic throttle body and must be correctly calibrated in the ECU.

Important

DBW installation requires correct pedal and throttle wiring, dual-channel calibration, plausibility checks and brake/driver-safety strategy. Do not treat the pedal as a simple single-channel TPS.

Product Details

Product: Haltech Bosch - DBW Pedal Assembly
Brand: Haltech
Category: Haltech Drive By Wire

This listing covers the product and application named above. Use the product title, part number where shown, and the existing technical information on this page to confirm it matches the required vehicle or engine combination.

Before Ordering

• Confirm the listed application matches the vehicle, engine or component being upgraded.
• Check whether supporting hardware, fabrication, wiring, fluids, gaskets or calibration are required for the installation.
• If the vehicle has non-standard modifications, confirm compatibility before purchase.

Built by Boost & Tune Support

Built by Boost & Tune can assist with installation, wiring integration, sensor setup and calibration where required. Contact us before ordering if you need help confirming suitability or planning the complete upgrade package.

Supplier

Haltech