Haltech Reverse / Back-up Camera Kit
Haltech Reverse / Back-up Camera Kit
Haltech Reverse / Back-up Camera Kit (HT-060400) adds reverse-camera functionality to the Haltech uC-10 display dash.
Camera specification
- CVBS composite video.
- 720 x 480 resolution.
- 170° viewing angle.
- IP67 camera.
- Optional on-screen guide lines.
Included
- Reverse camera.
- Licence-plate mounting bracket.
- Pre-terminated and labelled 6m / 19ft shielded harness.
- Double-sided mounting tape and screws.
Compatibility
Designed for the Haltech uC-10 camera input and requires uC-10 firmware v2.29.x or later.
Product Details
Product: Haltech Reverse / Back-up Camera Kit
Brand: Haltech
Category: Haltech Dash & Display
This listing covers the product and application named above. Use the product title, part number where shown, and the existing technical information on this page to confirm it matches the required vehicle or engine combination.
Before Ordering
- Confirm the listed application matches the vehicle, engine or component being upgraded.
- Check whether supporting hardware, fabrication, wiring, fluids, gaskets or calibration are required for the installation.
- If the vehicle has non-standard modifications, confirm compatibility before purchase.
Built by Boost & Tune Support
Built by Boost & Tune can assist with installation, wiring integration, sensor setup and calibration where required. Contact us before ordering if you need help confirming suitability or planning the complete upgrade package.
Application Checks
Confirm ECU or vehicle compatibility, connector/harness requirements, sensor range, power and ground requirements, DBW or other control needs and the calibration strategy before ordering. Wiring and sensor setup should be completed against the relevant pinout and configured in the ECU before final testing.
Supplier
Haltech