Haltech Knock Sensor - Genuine Bosch

Haltech Genuine Bosch Knock Sensor (HT-011100) is a non-resonant knock sensor suitable for performance engines where the ECU is configured to monitor the engine's specific knock frequency.

Features

• Genuine Bosch sensor.
• Non-resonant wide-frequency design.
• 8mm / 5/16in through-bolt mounting.
• Matching plug and two pins included.

Installation

Knock-sensor location, mounting-surface preparation and tightening torque materially affect the signal. The ECU must then be configured for the engine's knock frequency and appropriate gain/filter strategy.

Product Details

Product: Haltech Knock Sensor - Genuine Bosch
Brand: Haltech
Category: Haltech Sensor

This listing covers the product and application named above. Use the product title, part number where shown, and the existing technical information on this page to confirm it matches the required vehicle or engine combination.

Before Ordering

• Confirm the listed application matches the vehicle, engine or component being upgraded.
• Check whether supporting hardware, fabrication, wiring, fluids, gaskets or calibration are required for the installation.
• If the vehicle has non-standard modifications, confirm compatibility before purchase.

Built by Boost & Tune Support

Built by Boost & Tune can assist with installation, wiring integration, sensor setup and calibration where required. Contact us before ordering if you need help confirming suitability or planning the complete upgrade package.

Application Checks

Confirm ECU or vehicle compatibility, connector/harness requirements, sensor range, power and ground requirements, DBW or other control needs and the calibration strategy before ordering. Wiring and sensor setup should be completed against the relevant pinout and configured in the ECU before final testing.

Supplier

Haltech