Haltech Bosch 980cc injectors - Flowmatched set of 4 (0280158040)
Haltech Bosch 980cc injectors - Flowmatched set of 4 (0280158040)
Haltech Bosch 980cc Injectors - Flow-Matched Set of 4 (HT-080102) is a matched set of genuine Bosch high-impedance injectors for high-performance petrol and ethanol fuel systems.
Set contents
- 4 x Bosch 980cc injectors, flow matched as a set.
- 4 x matching Bosch EV1 connector and pin sets.
- Connector terminals and boots supplied.
Injector specification
- Bosch part number: 0280158040.
- High-impedance design.
- E85 compatible.
- Single-cone spray pattern.
Calibration
Use the correct Haltech/Bosch injector characterisation data rather than treating nominal flow rate as the only calibration value. Accurate dead-time and short-pulse data are important for idle, transient and low-load fuel control.
Product Details
Product: Haltech Bosch 980cc injectors - Flowmatched set of 4 (0280158040)
Brand: Haltech
Category: Haltech Fuel & Air
This listing covers the product and application named above. Use the product title, part number where shown, and the existing technical information on this page to confirm it matches the required vehicle or engine combination.
Before Ordering
- Confirm the listed application matches the vehicle, engine or component being upgraded.
- Check whether supporting hardware, fabrication, wiring, fluids, gaskets or calibration are required for the installation.
- If the vehicle has non-standard modifications, confirm compatibility before purchase.
Built by Boost & Tune Support
Built by Boost & Tune can assist with installation, wiring integration, sensor setup and calibration where required. Contact us before ordering if you need help confirming suitability or planning the complete upgrade package.
Supplier
Haltech